bb_guns
May 9, 2008, 7:41 PM
Views: 119460
Registered: Apr 25, 2002
Posts: 15
|
Nice work! You may want to consider adding in a paragraph about wear on a biner and how it affects strength. I know I have some old biners that are worn down a bit that I no longer trust. Basically, if the wear is visible, the biner is suspect - especially with the asymmetric light weight biners. Additionally, a section on how to clean a biner would be good. I do clean my biners, but I never lube them because I do not want them to pick up grit. One final item: Wire gate biners are less likely to ice up than standard gate.
(This post was edited by bb_guns on May 9, 2008, 7:45 PM)
|