no_email_entered
May 12, 2009, 1:09 AM
Views: 22179
Registered: Feb 1, 2008
Posts: 558
|
patbeaudet wrote: But the point with that Quadralette, it was intended to solve two problems encountered with the equalette i.e. 1- the master point witch require 2 to 3 biners (auto-lock mode) and its 1 load bearing strands and 1 capturing strands. wrong---use one locking biner for your [cinch, gri-gri, guide] using two strands with sliding x
In reply to: 2-it's uncapability to equalize more than two pieces at a time. huh? ---and for adding a 'shelf' to your equalette, tie another pair of limiting knots above the other two and clip in between on each side for your tie-in, then use the center for your direct/indirect belay for the second. done deal.
(This post was edited by no_email_entered on May 12, 2009, 1:09 AM)
|